• Glammer Flex creates a pearly mirror surface. 
• It has a beautiful gold-pearly hue.
• It allows for creating quick and spectacular designs

• Create any type of gel polish, gel, acrylic, or acrylgel nail design.
• Apply a product without a dispersion layer* and cure it following the curing instructions for the selected lamp.
• Use circular motions to rub in a minimal amount of the nail powder into a cured product.
• Remove the excess with the soft Cupcake Brush thoroughly.
• Secure the design with a top coat – Wet Look or Tip Top, remembering to secure the free edge.
• Cure the top coat in the MultiLed lamp for 30 seconds.
• Once you remove the hand from the lamp, wait for about 1 minute.
• If you choose Wet Look, wipe the nails with a wipe soaked in Shea Super Shine Effect Cleaner.
• To finish off, you can additionally apply your favourite nail care products.

*choose a product that suits your design:

1. gel polish design – Tip Top;
2. designs with an overlay created with such base coats as Protein Base, Mineral Base, or Whitemin Base – Dry Top, Tip Top, or coloured Arte Brillante gels;
3. gel or acrylgel designs – Dry Top, Shine On, Tip Top, or Arte Brillante.

Why is the mirror effect hard to attain? Why isn’t the surface evenly covered?

• The curing time has been too long.
• Too much time had passed from the moment the hand was taken out of the lamp and the moment the nail effect was rubbed into the nail surface.
• Too thin layer of the base product (especially around the cuticles and free edge).
• Too little nail powder has been used.
• The powder has been rubbed in for too long.

Why is there no mirror effect on the design? 

• The product has been cured for too long.
• Too thick product layer.
• Too much nail powder has been applied.
• The excess particles hadn’t been property cleaned before applying the top coat.